Apple Music Hear your music the way it was mastered. Get up to 3 months of Apple Music free, with lossless audio and Dolby Atmos. Try it free Ad · New subscribers only
SoundBench فارسی
Guides

Guitar String Frequencies: Standard Tuning in Hz

Every string on your guitar vibrates at a fixed frequency when it is in tune. Here are the exact numbers for standard tuning and other common instruments, and how to hit them.

Standard guitar tuning is E A D G B E, from the thickest string to the thinnest. Each of those notes has a frequency measured in hertz (Hz), the number of times the string vibrates per second. Knowing the numbers helps when your tuner shows a strange reading, when you tune a bass or ukulele, or when you want to play a reference tone to tune by ear.

All the values below assume the common concert pitch of A4 = 440 Hz. If a recording or ensemble uses a different reference, every note shifts by the same ratio, so the relationships between strings stay the same while the absolute numbers change.

Standard guitar tuning frequencies

Guitar notation is written one octave higher than it sounds, but the frequencies below are the real sounding pitches. The low E string vibrates at about 82 times per second, and the high E string at about 330 times per second, exactly two octaves higher.

StringNoteFrequency (Hz)
6 (thickest)E282.41
5A2110.00
4D3146.83
3G3196.00
2B3246.94
1 (thinnest)E4329.63

Bass, ukulele and violin

Other string instruments use different notes. A four-string bass is tuned like the lowest four guitar strings but one octave lower. A standard ukulele uses G C E A with a re-entrant high G. A violin is tuned in perfect fifths.

InstrumentStrings (low to high)Frequencies (Hz)
Bass guitar (4-string)E1 A1 D2 G241.20, 55.00, 73.42, 98.00
Ukulele (GCEA)G4 C4 E4 A4392.00, 261.63, 329.63, 440.00
ViolinG3 D4 A4 E5196.00, 293.66, 440.00, 659.25

Why the numbers are not round

Modern tuning uses equal temperament, where each semitone is the twelfth root of two times the one below it, about 1.0595. That is why E2 is 82.41 Hz and not a tidy 82 or 83. A tuner measures how far your string is from the nearest target in cents, where one semitone equals 100 cents. Being within a few cents is usually inaudible to most listeners.

Open strings also contain harmonics at two, three and more times the main frequency. A good tuner locks onto the fundamental, but a very thick string can briefly show a higher reading right after you pluck it. Let the note ring for a second before judging.

How to tune with the SoundBench Guitar Tuner

The quickest way to check these numbers against your own guitar is the SoundBench online tuner at soundbench.net/guitar-tuner/. It runs in your browser, listens through your microphone and shows a needle measured in cents.

  • Open soundbench.net/guitar-tuner/ and click Start tuner, then allow microphone access.
  • Choose your instrument so you can see the target note for each string, or use chromatic mode for anything else.
  • Pluck one string at a time and let it ring. Turn the tuning peg until the needle sits in the green zone and the note turns green.
  • Tune upward to the note: if you overshoot, loosen the string below pitch and bring it back up, which helps it stay in tune.
  • Recheck all six strings once you finish, because tightening one string slightly changes the neck tension.

Tuning by ear with a reference tone

If you prefer to tune by ear, or your room is too noisy for a microphone, play a pure tone at the string frequency and match it. The SoundBench Tone Generator at soundbench.net/tone-generator/ lets you type an exact frequency such as 82.41 or 110 and play a clean sine wave. Listen for slow beating between the tone and your string; the beats slow down and disappear as the pitches match.

If you want to practice the tuned instrument in time, the Metronome at soundbench.net/metronome/ is a good next step. To work out what key a song is in before you play along, try the BPM and key finder at soundbench.net/bpm-key-finder/.

Frequently asked questions

What frequency is the low E string on a guitar?

In standard tuning with A4 = 440 Hz, the low E string (6th string) is E2 at 82.41 Hz.

What is the frequency of A 440?

A4 is the A above middle C and is defined as 440 Hz in the common concert pitch standard. On a guitar it is found at the fifth fret of the high E string.

How accurate does guitar tuning need to be?

Within about 5 cents is close enough that most players and listeners cannot hear the difference. A cent is one hundredth of a semitone.

Related tools